91精品一区二区三区久久久久久_欧美一级特黄大片色_欧美一区二区人人喊爽_精品一区二区三区av

位置:51電子網 » 企業新聞

TUSB2046IBVF 4港口樞紐W /可選的串行eepm接口

發布時間:2017/10/10 9:59:00 訪問次數:388

燁弘軒電子最新到貨 有最新批號 朱生 13410068358 微信同號 可提供樣品 批量 方案 技術資料 技術支持 竭誠為您提供優質服務。需要查詢更多產品 www.yhx-group.com 。

TUSB2046IBVF TUSB2046IBVFR 4-Port USB Hub W/Optional Serial EEPROM Interface 有現貨 可添加我們聯系方式獲取最優惠價格

原廠原包原標原裝每一片都來自正規渠道每一片都可追溯

描述

The TUSB2046x is a 3.3-V CMOS hub device that provides one upstream port and four downstream ports in compliance with the Universal Serial Bus (USB) specification as a full-speed hub. Because this device is implemented with a digital state machine instead of a microcontroller, no firmware
programming is required. Fully compliant USB transceivers are integrated into the ASIC for all upstream and downstream ports. The downstream ports support full-speed and low-speed devices by automatically setting the slew rate according to the speed of the device attached to the ports. The configuration of the BUSPWR pin selects either the bus-powered or the self-powered mode.

Configuring the GANGED input determines the power switching and overcurrent detection modes for the downstream ports. If GANGED is high, allPWRONoutputs switch together and if anyOVRCURis activated, all ports transition to the power-off state. If GANGED is low, thePWRONoutputs and OVRCURinputs operate on a per-port basis.

The TUSB2046x provides the flexibility of using a 6-MHz or a 48-MHz clock. The logic level of the TSTMODE terminal controls the selection of the clock source. When TSTMODE is low, the output of the internal APLL circuitry is selected to drive the internal core of the device. When TSTMODE is high, the TSTPLL/48MCLK input is selected as the input clock source and the APLL circuitry is powered down and bypassed. The internal oscillator cell is also powered down while TSTMODE is high. Low EMI emission is achieved because the TUSB2046x can usee a 6-MHz crystal input. Connect the crystal as shown in Figure 6. An internal PLL then generates the 48-MHz clock used to sample data from the upstream port and to synchronize the 12 MHz used for the USB clock. If low-power suspend and resume are desired, a passive crystal or resonator must be used. However, a 6-MHz oscillator may be used by connecting the output to the XTAL1 pin and leaving the XTAL2 pin open. The oscillator TTL output must not exceed 3.6 V.

For 48-MHz operation, the clock cannot be generated with a crystal using the XTAL2 output because the internal oscillator cell supports only the fundamental frequency. Other useful features of the TUSB2046x include a package with a 0.8-mm pin pitch for easy PCB routing and assembly, push-pull outputs for thePWRONpins eliminate the need for pullup resistors required by traditional open-collector I/Os, andOVRCURpins have noise filtering for increased immunity to voltage spikes.


特性

Fully Compliant With the USB Specification as a Full-Speed Hub: TID #30220231

32-Pin LQFP(1)Package With a 0.8-mm Terminal Pitch or QFN Package With a 0.5-mm Pin Pitch

3.3-V Low-Power ASIC Logic

Integrated USB Transceivers

State Machine Implementation Requires No Firmware Programming

One Upstream Port and Four Downstream Ports

All Downstream Ports Support Full-Speed and Low-Speed Operations

Two Power Source Modes

Self-Powered Mode

Bus-Powered Mode

Power Switching and Overcurrent Reporting Is Provided Ganged or Per Port

Supports Suspend and Resume Operations

Supports Programmable Vendor ID and Product ID With External Serial EEPROM

3-State EEPROM Interface Allows EEPROM Sharing

Push-Pull Outputs forPWRONEliminate the Need for External Pullup Resistors

Noise Filtering onOVRCURProvides Immunity to Voltage Spikes

Package Pinout Allows 2-Layer PCB

Low EMI Emission Achieved by a 6-MHz Crystal Input

Migrated From Proven TUSB2040 Hub

Lower Cost Than the TUSB2040 Hub

Enhanced System ESD Performance

No Special Driver Requirements; Works Seamlessly With Any Operating System With USB Stack Support

Supports 6-MHz Operation Through a Crystal Input or a 48-MHz Input Clock


深圳市燁弘軒電子有限公司,我司2011年成立于中國經濟特區深圳.我司專注于為全球電子企業提供優質的電子零件供應服務,竭力打造全球品牌元器件零售與批量供應中心。專業經營各類電子元器件(集成電路IC,存儲芯片,分立器件,電源,無源元件,連接器,繼電器,傳感器,光電子,開關,保險元件,緊固件,開發工具,變壓器,測試與測量等)。 我們以低成本提供全方位一站式電子元件供應鏈采購方案,包括但不僅限于電子元件緊急物料搜尋,電子元件齊套供應、電子元件降低成本的長期供應,庫存寄售等一系列供應鏈解決方案。優勢供應各類電子組件.

==================

深圳市燁弘軒電子有限公司 重點客戶遍布中國內地 港 澳 臺地區,另外歐美發達國家以及 一代一路沿線發展中國家我司也有大量長期合作的優質客戶。

==================

深圳市燁弘軒電子有限公司 為一般納稅人 可開具17%增值稅票 有合作基礎可申請月結,延長賬期等多種供貨付款方式。

==================

公司經營目標:整合全球資源全 芯 全意為您服務。

公司服務宗旨:客戶虐我千百遍,我待客戶如初戀。

==================

主營 : 主動電子元器件 集成電路 IC 芯片 (AD TI MAX NXP ST LT XILINX ALTERA)等。

==================

聯系方式: 您可以通過下面任意一種方式 聯系到我們

企業網站:www.yhx-group.com

shype: pretying

阿里旺旺:cd_prety

微信號:yihuazhu666

銷售經理:朱宜華 深圳市燁弘軒電子有限公司 深圳市福田區上步工業區204棟5樓東座516室

電話: 0755-82548684 多線

傳真: 0755-82523504

手機: 13410068358

QQ : 746277983 1520285168

微信號: yihuazhu666

郵箱: zyh1818118@126.com

==================

燁弘軒電子鄭重承諾:

我司所售物料 可提供樣品 批量 方案 技術資料 技術支持。所有物料都是 原廠原包原標原裝,每一片都來自正規渠道,每一片都可追溯。


相關新聞

相關型號



 復制成功!
泾川县| 乌苏市| 彰化市| 石棉县| 大竹县| 武定县| 安多县| 吉水县| 本溪市| 水富县| 沁阳市| 林甸县| 南澳县| 含山县| 井研县| 和顺县| 吉安县| 奇台县| 山阴县| 襄城县| 勐海县| 旬邑县| 靖宇县| 德庆县| 桂平市| 霍邱县| 侯马市| 中西区| 永寿县| 宜宾市| 五莲县| 阜宁县| 霍林郭勒市| 兴义市| 砀山县| 克拉玛依市| 独山县| 焦作市| 南郑县| 乐清市| 盐源县|